How to Work With a European Hinges Jig

Apr 08, 21
How to Work With a European Hinges Jig

Using a European hinges jig for constructing sliding doors requires the following steps. The first thing you will do is get all the required materials ready. You should gather the following tools: screwdriver, wood blade, jigsaw, drill, nails, washer, hammer, tape measure, pencil, clamp meter, tape measure, saw, cutting board, drill bits, sandpaper, and the last important part is the screwdriver jack.

 european hinges jig

The next step is to mark the location on the wall where the opening of the door is to be located. You should use marking tape or a stick map to mark the location. You should also make sure that the location is straight so that you do not face any unnecessary curve while drilling the holes in your walls. After marking the location, you should go ahead and mark the size of the door that you want to mount the jig. Use the jigsaw to cut the holes for the hinges jig set on the wall accordingly. This may require you to go in for more than one hole but it is advisable to make sure that the holes are drilled accurately.


The next step would be mounting the jig. You should ensure that the jig is properly seated into the holes that have been made using the wood blade. For this, you will have to use the Brad drill. This kind of tool is very useful in such circumstances because it provides a very sturdy foundation for the jig. However, if you do not feel comfortable using the Brad drill, you can use the wood screws to firmly keep the jig in place.


CLICK HERE to Get This European Hinges Jig


Once the jig has been mounted into the desired location, the next step is to drill a pilot hole for inserting the screws. These screws will form the basis of the jig's hardware. You can use wood screws of various types - the self-locking and the bolt-on variety. You can also go in for stainless steel screws if you want to make your own set of European hinges jig.


After installing the hardware, the next thing you need to do is to assemble the hinges correctly. These can be assembled either by hand or by using the various devices that are available in the market. However, if you do not have enough time to assemble it manually, you can just use the hand tools provided. To make your job easier, you can just install them on the door using the special tap-able tap.


Once installed, you can start using the hardware. First of all, attach one side of the jig to the opposite side of the hinges. Once you are done with this, you can connect the other side of the jig with the corresponding side of the door. You need to do this carefully as you need to leave a gap between the two sides of the jig. You can start installing the other hinges onto the door once the first set is connected properly. It is best to practice a little before actually installing them.


When you have already installed all the jigs, the last step you need to do is to test each of them so that you can see which one is functioning properly. You can do this by putting the jig on the door and then pushing it down and back. If you hear a squeak when you push and release the jig, then you need to replace it with a new jig. This is the only way for you to know that the jig you have just installed is working properly.


To do this, you need to open and close your jaws. After this, test each of the hinges jig that you have just installed. If you find any problems with it, you need to replace it with a new one. Installing European hinges jig in your home will not take too much of your time because you just have to follow some instructions. You can use it anytime you want to install or repair doors.